This course is a follow up to the Manual Basic course and therefore it is recommended that a minimum of six weeks is left between completing the Basic course and attending this course to allow consolidation of previous learning.

The course is comprised of the following elements…

Day 1        

Review of Probe Calibration and Part Alignment

Offset alignment techniques

Use of Best Fit

External storage of data           

RPS Alignment

Day 2        

Use and applications of Loops

Formula Calculation

Use of Minimum / Maximum function

Introduction to Branching and the use of Sub-programs

Application of Head Data

If time permits the following may also be covered on request

Use and set-up of the Security function

Use of Geometric tolerances on the CMM (GD&T)